11
StarBoard Link EZ2
Englis
h
Safe Handling
Notice Contents Page(s)
- Select a level and stable position.
- Do not set it up near equipment that might generate electromagnetic waves or
radio frequencies, such as radio transmitters, televisions, copying machines or
air conditioners.
- Avoid locations that are dusty, that are subject to extremely high or low
temperatures or humidity, or that are exposed to direct sunlight.
P.2-1
The gap between the cursor and your finger (or pen) will become big in the
lower 13cm (5 inches) of the digitizer.
If you want to reduce the gap, place the digitizer keeping a minimum space of
13cm (5 inches) from the upper part of the centre of the projection area.
P.2-6
Use an input tool with a thickness of least 7 mm.
When inputting to this product, use a tool that is at least 7 mm. If a pen or
similar tool with a thickness of less than 7 mm is used, the input will be
unstable.
Also, do not use tools with a sharp tip, such as a ballpoint pen. If such a tool is
used incorrectly, it could damage the surface of the board.
P.3-1
Using infrared and compact cameras, this product captures the
image (shadow) of a pen or finger and detects the
corresponding coordinate position. Do not operate near
lighting that will obstruct the capture of the image.
- Locations where the surface or side of the projection area are exposed to direct
sunlight.
- Locations in which there are light fittings with many light bulbs or infrared
rays directly above the projection area.
P.2-10
P.4-4
NOTICE