Hitachi SBLE2-ML120201 Battery Charger User Manual


 
3-1
StarBoard Link EZ2
How to use
Englis
h
3. How to Use
3.1 How to Use Touch Mode
This section gives a basic description of how to use the board in touch mode.
3.1.1 Character Input
To input characters, use your finger or the stylus pen (sold separately).
- Using your finger
Touch the projection area with your finger extended. Do not allow any other part of your
body to touch or come near the projection area, as doing so may cause incorrect operation.
NOTICE
Use an input tool with a thickness of least 7 mm.
When inputting to this product, use a tool that is at least 7 mm. If a pen or similar tool
with a thickness of less than 7 mm is used, the input will be unstable.
Also, do not use tools with a sharp tip, such as a ballpoint pen. If such a tool is used
incorrectly, it could damage the surface of the board.