Filter
Top Products
2-10
E
n
g
lis
h
StarBoard Link EZ2
Assembly and Setup
2.3.5 Adjusting the Sensor
・Items to Check Before Making Sensor Adjustments
The following error may appear while using this product.
Check the following items if this error appears.
・There are no obstacles preventing the light from reaching the projection area, or silver surface of
the reflective bars.
・There is no dirt on the silver surface of the reflective bars.
If the problem is not corrected despite making the above checks, In the operating system you
are using, perform adjustment in accordance with "Sensor Adjustment Procedure" shown in
Section 2.3.5.1 in the case of Windows and 2.3.5.2 in the case of Mac OS.
2.3.5.1 Sensor Adjustment Procedure (Windows version)
[1] Press the "Adjust Camera" button on the "LSaDrv Touch Sensor Error" dialog box displayed
on the PC screen.
(*)This folder path may be changed since it depends on your Windows installation.
NOTICE
Using infrared and compact cameras, this product captures the image (shadow) of a
pen or finger and detects the corresponding coordinate position. Do not operate
near lighting that will obstruct the capture of the image.
・ Locations where the surface or side of the projection area are exposed to
direct sunlight.
・ Locations in which there are light fittings with many light bulbs or infrared
rays directly above the projection area.
In order to manually run the sensor adjustment wizard, open "My Computer" and
execute "LsCamWiz.exe" located under "C Drive" (*) → "Program Files" → "Hitachi
Software Engineering" → "FX-DUODriver".
Manual Startup
(Mac)
The window may be displayed
hidden behind another window.
(Windows)