Filter
Top Products
70
C H A P T E R 4 Advanced Configuration
70
Adding a routing link
To add a routing link to a VLAN that is not already configured:
1 Select VLAN/Routing Setup>Add.
2 Select the Setup an IP routing interface box.
3 Click Next, and follow the instructions in the Wizard windows.
Changing IP and IPX
details
To change the routing protocol details for an existing VLAN:
1 Select VLAN/Routing Setup.
2 Click Routing.
3 Select the Use IP routing or Use IPX routing box to
make active (if possible).
4 Double-click the required field, type the new value and select
the correct protocol parameters.
5 Click OK.
Adding a static route A static route is a permanent entry in the routing table and is a path to
IP network which is not announced by the RIP. A static route is an-
nounced to other switches or stacks using RIP. To add a static route:
1 Select VLAN/Routing Setup.
2 Click Advanced>IP Routing
3
Click Add
4 Double-click the required field, and type the new value.
5 Click OK.
500.book Page 70 Thursday, September 2, 1999 1:44 PM