Intel 550F Saw User Manual


 
72
C H A P T E R 4 Advanced Configuration
72
4 Click OK.
DVMRP Tunnels
Introduction This routing switch supports the Distance Vector Multicast Routing
Protocol (DVMRP). This enables IP multicast packets to be encapsu-
lated in an IP header, and sent through a tunnel between two specific
switches on a network that does not support DVMRP routing. The
tunnel is defined using IP addresses, a source IP address and a desti-
nation IP address.
Adding a tunnel A DVMRP tunnel must be set up in both switches over the tunnel.
1 Select VLAN/Routing Setup.
2
Click Advanced>IP Routing>DVMRP Tunnels.
3 Click Add.
4 Type the required information in the fields provided.
5 Click OK.
IP Multicast (IGMP pruning)
Warning when using
pruning
It is important to be aware of problems that may arise when using
IGMP pruning and IP Multicast addresses.
Warning When using the IGMP pruning, IP multicast packets not
based on IGMP are discarded.
500.book Page 72 Thursday, September 2, 1999 1:44 PM