Filter
Top Products
29
5-10.Measure Length
To measure the relative length between two points:
1. Click the Length button. The Length dialog box appears.
2. Click on one endpoint of a segment of interest, and move mouse while holding down left button.
The length of the segment is displayed in the dialog window in the Length box. To measure another segment,
click on two more points.
3. Click the End button in the dialog box. The value of the last segment measured is automatically
displayed on the image.
If checked the mark in <Disk Off>,
The circle as reference disk size is not shown
[Setting]>>[Other Setting]>>[Set Length]
You can change the basic length of Disk.
Default disk size is 1.6mm
You can measure the length between two images in order to compare.
But cannot record the value of length on the image. (To record the value, select one image)
Show two images, and Click the Length button.
5-11.Measure Cupdisk Rate
There are two methods to measure the cupdisk rate.
One is to use area, the other is to use length.
You can set this method in menu [Setting]>[Option Setting]
Check mark “Use length when measuring cup disk” -> Length method
Not check -> Area method