Filter
Top Products
'%"(&""'!
%J)%
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact your
<0.96;0<9;BA5<?6G216291&2?C602.0696AF for technical troubleshooting assistance before you proceed.
('"!
If all recommended possible areas
of possible cause have been
checked and the problem persists,
<;A.0AF<B?9<0.96;0<9;
BA5<?6G216291&2?C602.0696AF
#%" &
&, #'" &
Poor arc starting when the IDE-
ALARC® DC-600 VRD is in the
CV Sub-Arc or CV Innershield
Modes.
Machine has output but trips off
immediately when wire feed unit
trigger is activated
#"&&
(&
1. Make sure the proper welding
procedures are being used.
(wire feed speed , arc voltage
and wire size)
2. Check weld cables for loose or
faulty connections.
1. Remove output cables from
IDEALARC® DC-600 VRD. If
problem is resolved check for
external short between welding
cables. Also check control
cable (#75, #76, & #77) for
grounds or shorts.
%" !
"(%&"'"!
*!#%" &
"/@2?C2.99&.32AFB61296;2@12A.6921A5?<B45<BAA56@:.;B.9