Filter
Top Products
D-1
MAINTENANCE
D-1
ROUTINE MAINTENANCE
• Check weld cables, control cables and gas hoses
for cuts.
PERIODIC MAINTENANCE
• N/A
CALIBRATION SPECIFICATION
All calibration is factory set on the MAXsa™ 10 CON-
TROLLER.
MAXsa™ 10 CONTROLLER
SAFETY PRECAUTIONS
See additional warning information
throughout this operator’s manual and
the Engine manual as well.
------------------------------------------------------------------------
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts
such as output terminals or internal
wiring.
• When inching, electrode and drive
mechanism are “hot” to work and
ground and could remain energized
several seconds after the inch but-
ton is released.
• Turn OFF input power at welding power source
before installation or changing drive roll and/or
guide tubes.
• Welding power source must be connected to
system ground per the National Electrical Code
or any applicable local codes.
• Only qualified personnel should perform mainte-
nance work.
------------------------------------------------------------------------
WARNING