Filter
Top Products
OUTPUT PROBLEMS
Observe Safety Guidelines detailed in the beginning of this manual.
PROBLEMS
(SYMPTOMS)
POSSIBLE AREAS OF
MISADJUSTMENT(S)
RECOMMENDED
COURSE OF ACTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely,
contact the Lincoln Electric Service Department for technical troubleshooting assistance before you proceed.
Call 1-888-935-3877.
CAUTION
Major physical or electrical damage
is evident when the sheet metal
cover(s) are removed.
1. Contact your local authorized
Lincoln Electric Field Service
Facility for assistance.
1. Contact the Lincoln Electric
Service Department 1-800-833-
9353.
The machine is dead—no fan –no
output—no LEDs.
1. Make sure the input power switch
is in the ON position.
2. Check the main input fuses. If
open replace.
3. Make sure the correct input volt-
age is applied to the machine.
1. Check the input power switch for
proper operation. Also check the
associated leads for loose or
faulty connections. See Wiring
Diagram.
2. Perform the Input Filter Board
Test.
The main input fuses or breakers
repeatedly fail.
1. Make certain the fuses or break-
ers are properly sized for the
input draw of the machine.
2. The welding procedure may be
drawing too much input current or
the duty cycle may be too high.
Reduce the welding current
and/or reduce the duty cycle.
1. The Input Filter Board may be
faulty. Perform the Input Filter
Board Test.
2. The Main IGBT Inverter Board
may be faulty. Perform the Main
IGBT Inverter Board Low
Voltage Supply Test.
TROUBLESHOOTING AND REPAIR
F-4 F-4
INVERTEC® V205-T AC/DC™
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC