Filter
Top Products
Control/Display Board
FIGURE F.8 – CONTROL/DISPLAY BOARD LOCATION
CONTROL/DISPLAY BOARD TEST (continued)
PROCEDURE
1. Remove input power to the V205-T machine.
2. Using a phillips head screwdriver, remove the
case wraparound cover.
3. Perform the Capacitor Discharge Procedure
detailed earlier in this section.
4. Locate the control/display board and associat-
ed plugs . Do not remove plugs from the
board. See Figure F.8.
5. Carefully apply the correct input voltage to the
V205-T and check for the correct secondary
voltages per Tables F.2, F3 & F.4.
TROUBLESHOOTING AND REPAIR
F-24 F-24
INVERTEC® V205-T AC/DC™
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC