Filter
Top Products
Output Filter Board
FIGURE F.16 – OUTPUT FILTER BOARD LOCATION
OUTPUT FILTER BOARD TEST (continued)
PROCEDURE
1. Remove input power to the V205-T machine.
2. Using a phillips head screwdriver, remove the
case wraparound cover.
3. Perform the Capacitor Discharge Procedure
detailed earlier in this section.
4. Locate the Output Filter board and associated
plugs . Do not remove plugs from the board.
See Figure F.16.
5. Carefully apply the correct input voltage to the
V205-T and check for the correct secondary
voltages per Table F.12.
TROUBLESHOOTING AND REPAIR
F-36 F-36
INVERTEC® V205-T AC/DC™
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC