Filter
Top Products
Appendix 1 Cable
MITSUBISHI CNC
158
Appendix 1.40 SH41 Cable
Max. cable length: 1m (the maximum length of the cable when connected to the control unit via other units)
Application: Remote I/O cable
between remote I/O,
remote I/O-CNC control unit,
remote I/O-Operation panel I/O unit,
remote I/O-MITSUBISHI CNC machine operation panel A
(between remote I/O units in a panel)
(Note 1) Protect both ends of the cable with insulated bushing.
(Note 2) RIO1 and RIO3 can be used commonly.
(Note 3) Use this cable for short applications, such as bridging the remote I/O units in the same panel. Normally
use the FCUA-R211 cable with high noise withstand level.
[RIO1, RIO2, RIO3]
Connector: 1-178288-3
Contact: 1-175218-2 ×3
Recommended manufacturer:
Tyco Electronics
Wire material:
MVVS 3C×0.5mm
2
(MIC 3C×0.5mm
2
)
Recommended manufacturer: Takeuchi Densen
Connector: 1-178288-3
Contact: 1-175218-2 ×3
Recommended manufacturer:
Tyco Electronics
RIO1,RIO3(CSH41)
(CSH41)
1 2 3
X
RIO1,RIO3(CSH41)
1
2
3
TXRX
TXRX*
0V
1
2
3
TXRX
TXRX*
0V
(CSH41)