Mitsubishi Electronics M70V Router User Manual


 
Appendix 1 Cable
MITSUBISHI CNC
150
Appendix 1.32 G380 Cable
Max. cable length: 30m
Application: Optical communication cable
for wiring between drive units (outside panel)
for optical communication repeater unit
Use when the cable length is 10m or more to 30m or less.
(Note 1) Binding the cables too tight with tie-wraps could result in an increased loss or a disconnection. Use a
cushioning material such as a sponge or rubber when bundling the cables and fix so that the cables do not
move. Recommended clamp material: CKN-13SP KITAGAWA INDUSTRIES.
(Note 2) Never bundle the cables with vinyl tape. The plasticizing material in the vinyl tape could cause the PCF cable
reinforced sheath to damage.
(Note 3) Loop the excessive cable with twice or more than the minimum bending radius.
[OPT]
Connector: CF-2D101-S
Recommended manufacturer:
Japan Aviation Electronics
Wire material:
Hard clad type PCF optic cable
Recommended manufacturer:
Oki Electric Cable
Cable Minimum bending radius: R
2-core cable (section with reinforced sheath) 50mm
2-core cable (section without reinforced sheath) 25mm
OPT OPT
Section with
reinforced sheath
Section without reinforced sheath
OPT
1
2
OPT
1
2