Filter
Top Products
Introduction
This manual covers the items required for installing and connecting the MITSUBISHI CNC E70 Series. Read this
manual thoroughly and understand the product's functions and performance before starting to use.
This manual is written on the assumption that all optional functions are added, but the actually delivered device may
not have all functions.
The unit names, cable names and various specifications are subject to change without notice. Please confirm these
before placing an order.
This manual notes a reference chapter as "Chapter: Section: Paragraph".
(Example) For "1.3.1 List of Units":
"System Configuration: List of Configuration: List of Units"
("1.3.1 List of Units" included in "1.3 List of Configuration" of "1 System Configuration")
CAUTION
For items described as "Restrictions" or "Usable State" in this manual, the instruction manual issued by the machine
tool builder takes precedence over this manual.
Items that are not described in this manual must be interpreted as "not possible".
This manual is written on the assumption that all optional functions are added. Confirm the specifications issued by
the machine tool builder before starting to use.
Refer to the Instruction Manual issued by each machine tool builder for details on each machine tool.
Some screens and functions may differ depending on each NC system (or version), and some functions may not be
possible. Please confirm the specifications before starting to use.
The numerical control unit is configured of the control unit, display unit, operation board (keyboard unit, operation
panel I/O unit), servo drive unit, spindle drive unit, power supply unit + driver, servomotor, spindle motor, etc.
In this manual, the following items are generically called "controller".
- Control unit
- Display unit
- operation board (keyboard unit, operation panel I/O unit)
- Numerical control unit peripheral devices (input/output unit, safety unit)
In this manual, the following items are generically called "drive unit".
- Servo drive unit
- Spindle drive unit
- Power supply unit + driver
In this manual, the following items are generically called "motor".
- Servo motor
- Spindle motor