Filter
Top Products
CAUTION
Always install the motor with reduction gear in the designated direction. Failure to observe this could result in oil
leaks.
Always install a cover, etc., over the shaft so that the rotary section of the motor cannot be touched during motor
rotation.
When installing a coupling to the servomotor shaft end, do not apply impacts by hammering, etc. The detector could
be damaged.
Use a flexible coupling when connecting with a ball screw, etc., and keep the shaft core deviation smaller than the
tolerable radial load of the shaft.
Do not use a rigid coupling as an excessive bending load will be applied on the shaft and could cause the shaft to
break.
Do not apply a load exceeding the tolerable level onto the motor shaft. The shaft or bearing could be damaged.
Before using this product after a long period of storage, please contact the Mitsubishi Service Station or Service
Center.
Following the UN recommendations, battery units and batteries should be transported based on the international
regulations such as those determined by International Civil Aviation Organization (ICAO), International Air
Transport Association (IATA), International Maritime Organization (IMO) and U.S. Department of Transportation
(DOT).