Filter
Top Products
MQ SP-3035 Concrete Saw
—
S
p
ecifications
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 120
SPECIFICATIONS
Engine Wisconsin 35 hp V-4, electronic ignition, remote oil filter and above-frame
remote oil drain
Precleaner Centrifugal type, self-cleaning
Air Cleaner Four-stage air filtration, cartridge element w/ safety element
Fuel Tank 5 gallon molded tank, shutoff valve and central drain
Spindle Drive Belt Single 6-groove premium quality 3V Cross-Section Powerband
Belt Tensioners Single-point Spindle belt tensioner, self-adjusting rotary belt tensioners
throughout for accessories
Blade Range 14“ to 30“
Max Cut Depth 12.75”
Blade Guard Extra heavy design, slip-on type, w/quick-disconnect water hoses, usable on
either side, 20“ standard, 16”-20”-26”-30” optional
Spindle Assembly Fully-enclosed bearings and shaft, oil bath, protected seals, 1-1/2” diameter
Spindle, remote protected oil fill and vent, blade usable on either side.
Blade Flanges Quick-disconnect, taper-lock, 4.5” diameter collars w/ 24 water spray ports
Blade Flushing Minimum water usage system, panel-mounted flow control, 24 evenly
distributed water spray ports (12 per blade side)
Blade Control 12-volt hydraulic raise/lower system. Joystick-controlled at the operator’s
panel with plunge and raise buttons located on the control joystick
Blade Depth Stop Positive, heavy duty design w/ accurate depth gauge
Frame Heavy gauge laser-cut steel, box design, powder coat finish
Lift Point Integral balanced single-point lift
Balance Rear pivot design for quick maneuverability
Handlebars 3-position adjustable with in/out and storage positions, quick locks
Front Wheels 6” x 3”, “no maintenance” precision sealed bearings w/ extra end seals and
seal protectors; no grease points
Rear Wheels 11” x 3”
Drive System Hydro-Gear hydrostatic powered transaxle drive w/ infinite F-N-R speed
control, central joystick, remote filter. Cable control. Positraction w/ panel-
mounted lever.
Travel Speed Up to 225 feet per minute
Battery 12 volt, group 26, 425 cold cranking amps
Engine Controls Twist-lock throttle, choke, back-lit Spindle tach w/hour meter, volt meter, 3-
position ignition switch
Electrical Wiring Easy service loom
Night Light Standard, removable, usable either side of saw
Front Pointer Heavy gauge frame, 6” pointer wheel, tether rope
Rear Pointer Standard, adjustable
Tools 15/16” blade wrench standard
Unit Dimensions 46” long, 27-3/8” wide, 41” high (handlebars in storage position, w/o blade
collars)
Unit Weight 975 pounds, with oil, no fuel