Filter
Top Products
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 48
MQ SP-3035 CONCRETE SAW
Spindle Replacement
NOTE
To assure correct Spindle/Wheel alignment it is recommended that
this operation be performed by a Multiquip Authorized Service Center.
DO NOT unbolt the Spindle Mounting Blocks, as they have been
factory installed for correct Spindle/wheel alignment.
1. Remove the Spindle Drive Belts (see Replacing the Spindle Belt, above).
2. Tighten the Engine Mount Lock Bolts to prevent engine movement during step #3.
Fig. 34 — Engine Mount Lock Bolts
DANGER
To prevent the possibility of crush injury, always
ensure that the saw is securely supported whenever it
is lifted for maintenance.
3. Block the wheels then lift the saw to the full up position, and block up the front axle to prevent
accidental crush injury.
4. Disconnect the two hoses attached to the Spindle, and plug hoses and Spindle ports to prevent
drips and dirt contamination.
5. Support the Spindle to prevent tipping or shifting of weight.
6. Unbolt the Spindle Saddle Clamps using a 3/8” Allen wrench.
Engine Mount
Lock Bolt
Engine Mount
Lock Bolt