Multiquip SP303520 Saw User Manual


 
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 23
MQ SP-3035 CONCRETE SAW
Installing and Removing the Blade Guard
Blade Guards for the SP-3035 concrete saw can be installed on either side of the saw.
Verify the engine start switch is OFF before installing
blade.
WARNING
Remain clear of all parts of saw while installing blade to
prevent crush injury or death.
Installing the Blade Guard
1. Ensure on/off key is off. See Fig. 5 or Fig. 15
2. Slide the Blade Guard Mounting Clip onto the Guard Mounting Tab on the frame.
3. Connect the water delivery hose to the Blade Guard.
4. Ensure that the water tubes are pointed toward the water distribution grooves in the Blade
Collars. See Fig. 10
5. Make sure the front-hinged section of the Blade Guard is fully closed before use.
Fig. 9 — The Blade Guard installed
Blade Guard
rear section
Blade Guard
Mounting Clip
Blade Guard
hinged front
Water Delivery Hose
T
op Handle
Rear Handle