Filter
Top Products
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 22
MQ SP-3035 CONCRETE SAW
Stacking Blades for Wide Cuts
Remain Clear of all parts of saw while installing blade to
prevent crush injury or death.
Verify the engine start switch is OFF before installing
blade.
WARNING
Tighten the 5/8” blade-mounting bolt to 100-125 foot-
pounds torque.
Combining (stacking) blades to make wide cuts requires an optional Bushing Extension Kit.
Kit #18502 allows blade stacking from .375” to .75” thickness.
Kit #18501 allows blade stacking from .75” to 1.125” thickness.
1. Ensure on/off switch is off. See Fig. 5 or Fig. 15
2. Remove the existing blade. See Removing the Blade Fig. 7
3. Replace the standard Flange Bushing, Flange Pin, and Mounting Bolt that came with the saw
with the longer Bolt, Pin and Bushing which comes with the Kit.
4. Insert the Bushing and Mounting Bolt through the Outer Flange and Blades. The longer
bushing and bolt allow blades to be stacked together.
5. Align the Flange Pin through the stack of Blades into the Inner Flange.
6. Tighten the 5/8” Mounting Bolt to 100-125 foot-pounds of torque.
7. Install blade guard.
Fig. 8 — Blade Stacking
Tapered
Blade Shaft
Inner Collar
Mounting
Bolt
Collar
Bushing
Outer Collar
With Pin