Multiquip SP303520 Saw User Manual


 
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 49
MQ SP-3035 CONCRETE SAW
Fig. 35 — Spindle Replacement
7. Remove the Spindle.
DO NOT unbolt the Spindle Mounting Blocks, as they have been factory-installed
for correct Spindle/wheel alignment.
8. Fill the new Spindle with approved hydraulic oil and cap.
9. Perform Steps 1-5 in reverse order.
Fig. 36 — Maintain equal spacing when tightening Saddle Clamps
Tighten Saddle Clamp bolts equally, maintaining even spacing as you reattach the
Saddle Clamps. Torque bolts to 35 ft. lbs. Do Not over-torque. Apply medium
strength thread lock, Blue Loctite 242 or equivalent.
Spindle Mounting
Block
DO NOT REMOVE
Saddle
Clamps
Lower Belt
Protector
Spacing
Spacing
Spindle Mounting
Block
DO NOT REMOVE