Filter
Top Products
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 45
MQ SP-3035 CONCRETE SAW
Blade Flange Removal/Installation
Correct removal or installation of the Inner Blade Flange or Flange requires a Flange Puller
(option Part Number 18503) as shown below.
WARNING
Follow instructions closely to prevent injury from flying Blade Flanges!
Because of tapered fit between Blade Flange and Spindle, 5-10 tons
of force is needed to release the inner flange. Parts and tools can
become dangerous projectiles if instructions are not followed properly.
Fig. 31 — Using the Flange Puller
Removing the Inner Blade Flange
With the Outer Blade Flange in place, and the Blade Mounting Bolt loosened approximately ¼”:
1. With the three perimeter bolts holding the two Puller Plates together, slide the Horseshoe Plate
of the Flange Puller behind the (Shaft) side of the Inner Flange as shown above.
2. Tighten the center Puller bolt to remove the Inner Flange from Spindle.
Perimeter Bolt
Perimeter Bolt
Perimeter Bolt
Puller Bolt
Horseshoe Plate
Front Puller Plate