Filter
Top Products
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 59
MQ SP-3035 CONCRETE SAW
The drive wheels are aligned by adjusting the entire rear drive assembly.
1. Raise the saw halfway, then lift the rear of the saw until flanges touch the ground. Use suitable
supports to prevent tipping or shifting of weight.
2. Loosen the adjustment-side attachment bolts until washers spin freely.
3. Loosen pivot-side bolts enough to move the adjustment-side wheel in the appropriate
direction to achieve the desired alignment distance.
4. Tighten the Transaxle Attachment Bolts when the appropriate alignment distance is set.
Pivot Side | Adjustment Side
Fig. 46 — Drive Wheel Alignment Bolt Locations
Adjustment Side
Attachment Bolts
Pivot Side
Attachment Bolts