Filter
Top Products
6
wrenches are removed from the machine
before turning it on.
25. Keep safety guards in place at all times when
machine is in use. If removed for maintenance
purposes, use extreme caution and replace the
guards immediately after completion of
maintenance.
26. Check damaged parts. Before further use of
machine, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended
function. Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or
replaced.
27. Keep floor around machine clean and free of
scrap material, oil and grease.
28. Keep visitors a safe distance from work area.
Keep children away.
29. Make your workshop child proof with padlocks,
master switches or by removing starter keys.
30. Give your work undivided attention. Looking
around, carrying on a conversation and “horse-
play” are careless acts that can result in
serious injury.
31. Maintain a balanced stance at all times so that
you do not fall into blade or other moving parts.
Do not overreach or use excessive force to
perform any machine operation.
32. Use the right tool at the correct speed and feed
rate. Do not force a tool or attachment to do a
job for which it was not designed. The right tool
will do the job better and more safely.
33. Use recommended accessories; improper
accessories may be hazardous.
34. Maintain tools with care. Keep blades sharp
and clean for best and safest performance.
Follow instructions for lubricating and changing
accessories.
35. Turn off machine before cleaning. Use a brush
or compressed air to remove chips or debris —
not your hands.
36. Do not stand on machine. Serious injury could
occur if machine tips over.
37. Never leave machine running unattended. Turn
power off and do not leave band saw until
blade comes to a complete stop.
38. Remove loose items and unnecessary work
pieces from area before starting machine.
39. Keep hands out of line of saw blade.
40. Don’t use in dangerous environment. Do not
expose machine to rain or use in wet or damp
locations. Keep work area well lighted.
41. Remove safety key from switch whenever band
saw is turned “OFF”, and keep safety key out of
reach of unauthorized persons or children.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or
possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or
possibly even death.
4.0 About this manual
This manual is provided by Powermatic covering the safe operation and maintenance procedures for a
Powermatic model PM1500 Band Saw. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. Your machine has been
designed and constructed to provide years of trouble-free operation if used in accordance with the instructions
as set forth in this document.
This manual is not intended to be an exhaustive guide to band saw operational methods, use of jigs or after-
market accessories, choice of stock, etc. Additional knowledge can be obtained from experienced users or
trade articles. Whatever accepted methods are used, always make personal safety a priority.
Retain this manual for future reference. If the machine transfers ownership, the manual should accompany it.
Read and understand the entire contents of this manual before attempting assembly
or operation! Failure to comply may cause serious injury!