Filter
Top Products
16
ASSEMBLY
TO INSTALL THE STORAGE TRAY
See Figure 10.
n Locate the pre-assembled storage tray.
n Completely remove the screw and hex nut from one side
of the storage tray assembly.
n Place the storage tray assembly around column and
above collar. Securely tighten in place using screw and
hex nut. Make sure the storage tray is located above
the column collar. Be careful not to overtighten the hex
nuts.
TO INSTALL THE FEED HANDLES
See Figure 11.
n Locate three (3) feed handles.
n Screw the feed handles into the threaded holes in the
hub and tighten.
n Tighten feed handles using the open end of the hex box
wrench included with drill press.
TO INSTALL THE CHUCK
See Figure 12.
n Clean the tapered surfaces on the chuck and spindle
with a clean cloth. Make sure there are no foreign
particles sticking to these surfaces. The slightest piece
of dirt on these surfaces will prevent the chuck from
seating properly. This will cause the drill to “wobble”.
n Slide chuck onto spindle of drill press.
n Push up on chuck assembly as you rotate it.
n Unlock table support lock and raise table so its about
two inches below tip of chuck.
n Turn chuck sleeve clockwise and open jaws in chuck
completely.
n Place a piece of wood on table. Turn feed handles
counterclockwise and force chuck against table until
chuck is secure.
Fig. 10
Fig. 11
Fig. 12
®
®
STORAGE
TRAY
SCREW
HEX NUT
®
®
FEED HANDLE
HUB
®
®
CHUCK
SPINDLE