Filter
Top Products
21
TO TILT TABLE
See Figure 21.
To use the table in a bevel (tilted) position:
n Loosen the set screw under table bevel lock with hex
key. Loosen bevel lock bolt with the hex box wrench
(included).
n Tilt table to desired angle by reading bevel scale.
Retighten bevel lock and set screw.
WARNING:
To reduce the risk of injury from spinning work
or tool breakage, always clamp workpiece
and backup material securely to table before
operating drill press with the table tilted.
To return table to original position:
n Loosen set screw and bevel lock, tilt table back to 0° on
bevel scale and retighten set screw, then tighten bevel
lock.
OPERATION
Fig. 21
0
10
20
30
40
10
20
30
40
0
BEVEL SCALE
SET
SCREW
BEVEL LOCK
BOLT