Filter
Top Products
18
19
ASSEMBLY
TO INSTALL THE HERC-U-LIFT™ MOBILE
BASE TO THE LEG STAND
See Figures 14 - 16.
WARNING:
Do not lift the saw without help. Hold it close to
your body. Keep your knees bent and lift with
your legs, not your back. Ignoring these precau-
tions can result in back injury.
n Locate the following hardware (see page 16):
2 rear tubes
1 center brace
1 unlock pedal assembly
2 front tubes
1 tube support
1 U-bolt tube
1 U-bolt
4 swivel casters
To assemble the lower section:
n Thread flange nuts (nuts face the U-bolt) onto the U-bolt
as far as they will go.
n Slide the U-bolt into the center holes on the U-bolt tube
and secure in place using hex nuts.
n Place the front tube on top of the U-bolt tube. Insert
screws (from blister pack) into the aligned holes on both
the tube and support. Fingertighten using flanged nuts.
NOTE: The small holes on the front tube must be facing
up.
n Place the tube support under the front tube and secure in
place with the screws and lock nuts from blister pack.
n Repeat for other side of the lower section.
To assemble the upper section:
n Place the unlock pedal assembly on top of the rear tube.
Secure in place using the screws and lock nuts.
n Place the caster up through the hole in the center brace
then through the rear tube as shown in figure 14. Secure
caster using the hex nut with serrated washer. Repeat for
other side.
To assemble the Herc-U-Lift™ to the leg stand:
n Place the caster up through the hole in the lower section
as shown in figure 14. Secure caster using the hex nut
with serrated washer. Repeat for other side.
n Follow above step for attaching the casters to the upper
section.
n Install the four leg brackets on the inside of each leg using
hex head screws (1/4-20 x 1/2 in.) and lock nuts. Tighten
securely.
n Place the lower section under the leg stand with the ends
of the tube under the leg brackets. Place a hex head
screw with washer through the leg bracket and the end
CASTER
Fig. 14
Fig. 15
LEG
BRACKET
HERC-U-LIFT™, LOWER SECTION
HERC-U-LIFT™, UPPER SECTION
UNLOCK PEDAL
ASSEMBLY
SMALL HOLE
ON TOP
SMALL HOLE
ON TOP
SMALL HOLE
ON TOP
HEX NUT
U-BOLT
TUBE
SUPPORT
FRONT
TUBE
CENTER
BRACE
CASTER
REAR TUBE
HEX
NUT
HEX NUT
SCREW
(1/4-20 x 1- 5/8 in.)
SCREW
(1/4-20 x 2 in.)
U-BOLT
TUBE
SCREW
(1/4-20 x 1- 1/2 in.)