Filter
Top Products
SUPER PRO GUN &
SUPER PRO GUN II
9. Set the 5105-6-1 (Toggle Washer) into the washer seal seat of the
5110-1-1 (Porting Plate) large side down.
10. Set the 5110-6-1 (Cylinder Gasket) over the screws, matching the
slots in the 5110-1-1 (Porting Plate)
11. Carefully position the 5106-00-01 (Gun Actuator Assembly) over
the 5110-7-1 (Gun Handle Assembly) and fasten with the two
5105-12-1 (Front Screws) and the 5105-13-1 (Rear Screws).
12. If necessary, adjust the 5105-8-1 (Trigger Lock) by pulling the
5105-16-1 (Trigger) to “full out”, then flip the Trigger Lock up until it
hits the smallest part of the 5110-8-1 (Trigger Lock Screw).
Loosen the 7102-6-4 (Socket Cup Point Set Screw) and adjust the
Trigger Lock Screw until it clears with minor interference. The
locking legs on the Trigger Lock Screw must be vertical. The
Trigger Lock should lock the trigger in both the open and closed
position. Once adjusted, tighten the 7102-6-4 (Socket Cup Point
Set Screw).
13. With the two 7102-8-8 (Slotted Pan Head Screws), mount the
5105-2-1 (Trigger Guard).
NOTE
The slot in the side of the 5110-1-1 (Porting Plate) must line up with the slot
in the 5110-7-1 (Gun Handle).
6