Filter
Top Products
SUPER PRO GUN &
SUPER PRO GUN II
Fig. 3.6
18. Install the 5104-2-1 (Valve Rod) through the resin side of the gun.
Use the 9301-5-1 (Seal Installation Tool) to center the Valve Rod
in the 5104-1-1 (Gun Block).
19. Install and hand tighten the 5104-8-1 (Packing Nut) onto the resin
side of the 5401-1-1 (Gun Block).
NOTE
Make sure that the Valve Rod is correctly aligned; the larger hole goes on the
resin side, while the smaller hole goes on the catalyst side. See Fig. 3.6.
NOTE
The middle hole, into which the actuating stem will be inserted, must also be
correctly aligned. One end of the hole has a relief in the threads, which
should face down. See Fig. 3.6.
11