Filter
Top Products
SUPER PRO GUN &
SUPER PRO GUN II
4
NOTE
The slot in the side of the 5105-5-1 (Porting Plate) must line up with the slot
in the 5105-1-1 (Gun Handle).
5. Set the 9203-2-1 (Compression Spring) into the spring seat
located in the upper cavity of the 5105-1-1 (Gun Handle).
6. Place the small pinhole in the 5105-3-1 (Slide Valve) over the pin
through the 5105-14-1 (Trigger Stem), and push down
compressing the spring into the handle cavity.
7. Place the 5105-4-1 (Porting Plate Gasket) over the screws,
matching the slot to the slot in the 5105-1-1 (Gun Handle).
8. Lightly lubricate the flat side of the 5105-5-1 (Porting Plate) with
6706-3-1 (Pro Gun Oil) and push it over the 5105-3-1 (Slide Valve)
keeping the Slide Valve connected to the 7203-4-9 (Slotted Spring
Pin) in the 5105-14-1 (Trigger Stem).
9. Set the 5105-6-1 (Toggle Washer) into the washer seal seat of the
5105-5-1 (Porting Plate) large side down.
10. Set the 5105-7-1 (Cylinder Gasket) over the screws, matching the
slots in the 5105-5-1 (Porting Plate)
11. Carefully position the 5106-00-01 (Gun Actuator Assembly) over
the 5105-00-01 (Gun Handle Assembly) and fasten with the two
5105-12-1 (Front Screws) and the 5105-13-1 (Rear Screws).
12. If necessary, adjust the 5105-8-1 (Trigger Lock) by pulling the
5105-16-1 (Trigger) to “full out”, then flip the Trigger Lock up until it
hits the smallest part of the 5105-11-1 (Trigger Lock Screw).
Loosen the 7102-6-4 (Socket Cup Point Set Screw) and adjust the
Trigger Lock Screw until it clears with minor interference. The locking
legs on the Trigger Lock Screw must be vertical. The Trigger Lock
should lock the trigger in both the open and closed position. Once
adjusted, tighten the 7102-6-4 (Socket Cup Point Set Screw).
13. With the two 7102-8-8 (Slotted Pan Head Screws), mount the
5105-2-1 (Trigger Guard).
SUPER PRO GUN II
Handle Assembly 5110-7-1
See Figs. 9.5 & 9.6 for exploded schematic drawings
1. Carefully install the 5105-9-1 (Trigger Nut Seal) over the
5105-10-1 (Trigger Nut).
2. Coat the 7304-4-1 (Lip Seal) with 6706-3-1 (Pro Gun Oil), and
push it into the 5105-10-1 (Trigger Nut).