Filter
Top Products
SUPER PRO GUN &
SUPER PRO GUN II
7. Press firmly, or tap with a hammer until the seal assembly bottoms
out in the 5104-1-1 (Gun Block), then gently remove the Seal
Installation Tool.
8. Hold the 9301-4-1 (Catalyst Seal Alignment Tool) firmly with a pair
of pliers.
9. Insert the tapered end of the 9301-4-1 (Catalyst Seal Alignment
Tool), into the 5104-1-1 (Gun Block) through the catalyst fitting port
on the back of the Gun Block.
10. Gently press and move the Seal Alignment Tool around until the
holes in the 5104-6-1 (Teflon Catalyst Seal) align with the catalyst
port in the 5104-1-1 (Gun Block) See Fig. 3.3.
11. Install and hand tighten the 5104-8-1 (Packing Nut).
12. Install the resin seal components into the 9301-5-1 (Seal
Installation Tool) in the following order: 5104-7-1 (Packing Ring),
5104-5-1 (Teflon Resin Seal), and the 5104-4-1 (Relief Spacer).
See Fig. 3.4.
13. Insert the Seal Installation Tool into the resin port of the 5104-1-1
(Gun Block) See Fig. 3.4.
NOTE
Before inserting the Seal Alignment Tool, align the holes in the 5401-5-1
(Teflon Resin Seal) with the holes in the 5401-1-1 (Gun Block) as closely
as possible.
9
NOTE
Before inserting the Seal Alignment Tool, align the holes in the 5401-6-1
(Teflon Catalyst Seal) with the holes in the 5104-1-1 (Gun Block) as closely
as possible.
Fig. 3.3