Filter
Top Products
Hardware setup
S1A53844 01/2011 15
Protection Against Interference
•
Use the Schneider Electric cable with 2 pairs of shielded twisted conductors (reference: TSXCSA100,
TSXCSA200, TSXCSA500).
• Keep the Modbus cable separated from the power cables (30 cm (11.8 in.) minimum).
• Make any crossovers of the Modbus cable and the power cables at right-angles, if necessary.
For more information, please refer to the TSX DG KBL E manual: “Electromagnetic compatibility of industrial
networks and fieldbuses”.
Ethernet bridge
(TSX ETG 100)
Screw terminal RS485 3 m cable fitted with an RJ45 connector and stripped at the other
end
VW3 A8 306 D30
Serial port PC Male SUB-D 9 RS232 serial
port PC
RS232/RS485 converter and
3 m cable fitted with an RJ45 connector and stripped at the other
end (for connection to the screw terminals of the LU9GC3 splitter
block)
TSX SCA 72 and
VW3 A8 306 D30