Filter
Top Products
S1A53844 01/2011 19
Configuration
3
Configuration
What's in this Chapter?
This chapter contains the following topics:
The settings of communication-related parameters can be changed from the operation panel or from Modbus
(PLC, computer or controller) or from graphic display option.
Note that there are two types of parameters: parameters whose settings take effect immediately after the
setting and parameters whose settings do not take effect until the drive is turned back on or reset. In the table
below, these 2 types are mentioned in the column "valid" by "After setting" and "After power cycle".
Topic Page
Configuration of the communication parameters 20
Configuration of the control source 21
Configuration of the indirect blocks 27
Configuration of the communication interruption 28