Filter
Top Products
Parameter list
44 S1A53844 01/2011
Referring to the Altivar 212 programming manual
General
Parameters are decribed in the Altivar 212 programming manual.
For communication purposes, the section "Table of parameter and data" references Modbus address, unit,
range... The table below is an abstract, just for example.
Additionnal parameter, not listed in the Altivar 212 programming manual, are described in the present section.
• "Modbus address" identifies the parameter for communication.
In Modbus protocol, it is also called "register address" or "Parameter address".
• "Adjusment range" or "Range" means the data cannot be written outside the range.
The data is expressed in the decimal notation. For writing the data through the communication function,
take the minimum setting unit into consideration, and use hexadecimal notation.
• "Minimum setting unit" is the unit of a single data.
For example, the "Minimum setting unit" of [Acceleration time 1] (ACC) is 0.1. 1 corresponds to 0.1s. For
setting the ACC to 10 seconds, transmit 16#03E8 by communication [10÷0.01=1000=16#03E8].
Submenu or parameter
description
Modbus
address
Setting Unit Default
setting
[5 LAST PARAM CHANGE] (AUH)
History function
Operation panels parameters in groups of five in
the reverse order to that in which their settings
were changed (possible to edit).
--
[Quick menu] (AUF)
Wizard function
The AUF submenu provides ready access to
the ten basic parameters commonly used in
programming the drive.
In many cases, programming the ATV212 drive
is complete when these 10 parameters and
motor parameters have been properly set.
--
[Auto ramp] (AUI)
Automatic acceleration/ deceleration
0
16#0
0 [Disabled]: Manual
1 [Enable]: [Acceleration time 1] (ACC) and
[Deceleration time 1] (dEC)
2 [ACC only]: [Acceleration time 1] (ACC) only
-1
[Acceleration time 1] (ACC)
Slope of the acceleration ramp and
the time it takes for the output
frequency of the
drive to increase from 0 Hz to the
setting of [Max frequency] (FH)
9
16#9
0.0 to 3200 s According
to drive
model