SUPER MICRO Computer 6014H-8 Stud Sensor User Manual


 
D-1
Appendix D: System Specifications
Appendix D
System Specifications
Processors
Single or dual Intel
®
Xeon
TM
604-pin processors at a front side
(system) bus speed of 800 MHz
Note: Please refer to the support section of our web site for a complete listing of supported
processors. (http://www.supermicro.com/support/)
Chipset
Intel E7520 chipset
BIOS
4 Mb Phoenix
®
Flash ROM
Memory Capacity
6014H-82 (X6DHR-8G2): Eight 240-pin DIMM sockets supporting up to
16 GB of low-profile, registered ECC DDR2-400 SDRAM
6014H-8/6014H-X8 (X6DHR-8G/X6DHR-X8G): Eight 184-pin DIMM
sockets supporting up to 16 GB of low-profile, registered ECC DDR333
SDRAM or 32GB of low-profile, registered ECC DDR266 SDRAM
Note: Interleaved memory - requires memory to be installed two at a time. Memory speed is
dependant on processor front side bus speed. See the memory section in Chapter 5 for
details.
SCSI Controller
Adaptec AIC-7902 for dual channnel, Ultra320 onboard SCSI
Zero Channel RAID supported
SCSI Backplane
One (1) SCA813S 1U SCSI backplane with SAF-TE compliance
SCSI Drive Bays
Four (4) drive bays to house four (4) standard 1" 80-pin SCA SCSI
drives