Filter
Top Products
6-2
SUPERSERVER 6014H-8/6014H-82/6014H-X8 Manual
Figure 6-1. Chassis: Front and Rear Views
System Reset
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF2 connector on the serverboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF2 on the serverboard to the appro-
priate header on the Control Panel PCB (printed circuit board). Make sure
the red wire plugs into pin 1 on both connectors. Pull all excess cabling out
of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3:
System Interface" for details on the LEDs and the control panel buttons.
Details on JF2 can be found in "Chapter 5: Advanced Serverboard Setup."
Control PanelSystem LEDs
Main Power
Slim-Line CD-ROM Drive Floppy Drive
SCSI Drives
External SCSI Port
PCI Expansion SlotsUSB0/1
Mouse/KeyboardPower Supply VGA Port
COM1 Port
Ethernet Ports
Low-Profile Release Tab (see page 5-9)
Upper Screw
Lower Screw