Filter
Top Products
5-8
SUPERSERVER 6014H-8/6014H-82/6014H-X8 Manual
Figure 5-5a. Side View of DIMM Installation into Slot
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward
to free the DIMM from the slot.
Memory Support
The X6DHR-8G2 has eight 240-pin DIMM slots that can support up to 16 GB
of registered ECC DDR2-400 SDRAM. The serverboard has has been de-
signed to support 2 GB DIMM modules for each memory slot, but it has only
been validated with 1 GB memory modules.
The X6DHR-8G/X6DHR-X8G has eight 184-pin DIMM slots that can support
up to 16 GB of low-profile, registered ECC DDR333 SDRAM or 32GB of low-
profile, registered ECC DDR266 SDRAM. The serverboard has has been
designed to support 2 GB DIMM modules for each memory slot, but it has only
been validated with 1 GB memory modules. If registered ECC DDR333
(PC2700) memory is used, four double-banked DIMMs or six single-banked
DIMMs are supported.
All three serverboards use an interleaved memory scheme, so memory mod-
ules must be installed two at a time (two DIMMs in the same bank). All
memory modules should be the same size and speed.
Figure 5-5b. Top View of DIMM Slot