Filter
Top Products
Infrared Gas Analyzer
Teledyne Analytical Instruments vii
Operation .....................................................................................35
3.1 General Information 35
3.2 Display and Available Menus 36
3.3 The Display Screen 38
3.3.1 Measurement Mode 38
3.3.2 Setting/Selection Screen 40
3.4 Basic Operation 41
3.5 Setting Up the Analyzer in the User Mode 42
3.5.1 Switch Ranges 42
3.5.1.1 Manual Range Switching 43
3.5.1.2 Range identification contact operation 44
3.5.1.3 Remote Range Selection 45
3.5.1.4 Autoranging 46
3.5.2 Calibration Parameters 46
3.5.2.1 Calibration Value 46
3.5.2.2 Setting of Manual Zero Calibration 48
3.5.2.3 Setting of calibration range 50
3.5.2.4 Setting of auto calibration component/range 51
3.5.3 Alarm Setting 53
3.5.3.1 Configuring the Alarms 55
3.5.3.2 Hysteresis Setting 56
3.5.4 Setting of Auto Calibration 58
3.5.4.1 Auto Calibration 58
3.5.4.2 Gas Flow Time Setting 59
3.5.4.3 Cycle Setting Range 60
3.5.4.4 Remote Start 62
3.5.4.5 Forced Run/Stop of Auto Calibration 62
3.5.5 Setting of Auto Zero Calibration 65
3.5.5.1 Auto Zero Calibration 65
3.5.5.2 Forced run/stop of auto zero calibration 68
3.5.6 Peak Alarm Setting 70
3.5.7 Parameter Setting 73