Chapter 14 Quality of Service (QoS)
P-870HN-51D User’s Guide
180
14.6 The Policer Setup Screen
A policer is a QoS policy.
Click QoS > Policer Setup to open the following screen. The P-870HN-51D can
control ingress (or incoming) traffic by dropping packets that exceed the
committed rate and/or committed burst size specified in this screen.
Figure 92 QoS > Policer
The following table describes the labels in this screen.
Table 65 QoS > Policer Setup
LABEL DESCRIPTION
Add Click this button to create a new policy.
No This field displays the index number of the policy.
Active Select the check box to enable the policy.
Name This is the name of the policy.
Regulated
Classes
This shows to which classes the policy applies.
Meter Type This shows the method that the P-870HN-51D uses for determining
which packets to pass, drop or mark (DSCP), whether it’s Simple
Token Bucket, Single Rate Three Color Meter or Two Rate Three
Color Meter. Refer to Section 14.8.2 on page 186 for information on
these meter types.
Parameter Committed Rate - This shows the maximum committed rate for the
specified class/es.
Committed Burst Size - This shows the maximum committed burst
size for the specified class/es.
