Chapter 14 Quality of Service (QoS)
P-870HN-51D User’s Guide
182
The following table describes the labels in this screen.
Table 66 QoS > Policer Setup: Edit
LABEL DESCRIPTION
Enable Select this to have the P-870HN-51D pass, drop or mark packets
that exceed the committed rate and/or committed burst size
specified in this screen.
Meter Type Select the method that the P-870HN-51D uses for determining which
packets to pass, drop or mark (DSCP). Choices are: Simple Token
Bucket, Single Rate Three Color Meter and Two Rate Three
Color Meter. Refer to Section 14.8.2 on page 186 for information on
these meter types.
Committed
Rate
Enter the maximum committed rate for the specified class/es.
Committed
Burst Size
Enter the maximum committed burst size for the specified class/es.
Conforming
Action
Select the action that the P-870HN-51D applies to packets that
conform to the meter type selected. Choices are Pass, Drop and
DSCP mark.
• Pass - the packet is allowed to flow to its destination.
• Drop - the packet is discarded.
• DSCP mark - the packet is given a DSCP mark and processed
accordingly. See Section 14.8.1 on page 185 for information on
DSCP mark.
Non-
comforming
Action
Select the action that the P-870HN-51D applies to packets that do not
conform to the meter type selected. Choices are Pass, Drop and
DSCP mark.
• Pass - the packet is allowed to flow to its destination.
• Drop - the packet is discarded.
• DSCP mark - the packet is given a DSCP mark and processed
accordingly. See Section 14.8.1 on page 185 for information on
DSCP mark.
Regularted
Classes Member
Setting
Use the Add and Remove buttons to select or deselect classes to
which the policy applies.
Available Class This shows the available classes.
Selected Class This shows classes to which the policy applies.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the P-870HN-51D.
Cancel Click Cancel to begin configuring this screen afresh.
