Chapter 5 WAN Setup
P-870HN-51D User’s Guide
76
5.5.1.3 WAN IP Address and DNS Server
The screen differs by the encapsulation you selected in the previous screen. See
Section 5.6 on page 84 for more information.
Rate Limit Enter the maximum transmission rate in Kbps for traffic sent through the
WAN connection. Otherwise, leave this field blank to disable the rate
limit.
This field is not available for an ATM connection.
MTU [1-1500] Type the maximum size of each data packet, in bytes, that can move
through this interface. If a larger packet arrives, the P-870HN-51D
divides it into smaller fragments. Allowed values are 1 - 1500. Usually,
this value is 1500.
Tag VLAN ID
for egress
packets
Select this option to add the VLAN tag (specified below) to the outgoing
traffic through this connection.
This field is available when the Connect interface is in VLAN MUX mode.
Enter 802.1P
Priority
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into
a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through
this connection. The greater the number, the higher the priority level.
This field is available when the Connect interface is in VLAN MUX mode.
Enter 802.1Q
VLAN ID
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
This field is available when the PTM interface is in VLAN MUX mode.
Back Click this button to return to the previous screen.
Next Click this button to continue.
Table 16 WAN Configuration: Service Type
LABEL DESCRIPTION
