Filter
Top Products
9.:=@
(@6;4 A52 *<?8=6202 9.:= – This clamp easily
secures a workpiece to the table or base.
1. Insert the clamp’s knurled bar down into a clamp
post hole; there are two post holes located in the
base behind the fence. The knurled end must be
in the post at least 1/2".
2. Slide the clamp down until its rubber foot contacts
the workpiece.
3. Adjust the clamp height so it does not touch the
sliding fence.
4. Rotate the clamp’s knob until the workpiece is
firmly held in place.
5. Move saw head up and down and forward and
back to be sure it clears the clamp.
'52?2 :.F /2 2EA?2:2
0<:=<B;1 0BA@ D52?2 09.:=
0.;;<A /2 B@21 &B==<?A D<?8=6202 D6A5 F<B?
5.;1<BA@612A52K"<.;1@LG<;2<;<AA?FA<
0BA @5<?A =6202@ A5.A 0.;;<A /2 09.:=21 .;1
0.B@2F<B?5.;1A</26;A52K"<.;1@LG<;2
64B?2*<?8=62029.:=
9.:=@ – Other hold-down devices such as C-
clamps can be used to hold the workpiece firmly
against the table and the fence. Make sure the
clamps are clear of the cutting path.
&9616;42;02@
'< =?<C612 @B336062;A :6;6:B:
@=.06;4 3?<: 5.;1 A< @.D
/9.12 2EA2;1 A52 @9616;4 32;02@ .;1 /.@2
2EA2;@6<;@D52;:.86;42EA?2:2/2C29:6A2?<?
0<:=<B;10BA@.
#=2?.A6;4&9616;42;02@
1. Loosen the fence lock knob by turning counter-
clockwise.
2. Slide the fence to the desired position.
3. Lock fence in desired position by turning lock knob
clockwise.
64B?2
%2:<C6;4&9616;42;02@
When performing compound cuts, miter cutting at
extreme bevel angles the fence may need to be
removed.
1. Rotate the fence lock knob counter clockwise seven
rotations.
2. Lift up on fence to remove.
64B?2
!
*%""
Clamp
Workpiece
*%""
!
Sliding Fence
Fence Lock
Knob
Fence Lock
Knob
!
$?2=.?6;43<?&.D#=2?.A6<;@
*<?8=6202&B==<?A
BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 29