Filter
Top Products
16 FibreSTORE RAID System: Rack Installation Guide
Step 3. Installing a Disk Enclosure
Before you can install the disk enclosure, you must first remove the enclosure slide rails
from the rack, then you need to attach the enclosure slide rails to the disk enclosure(s).
Instructions for this procedure are provided below.
Removing Enclosure Slide Rails from the Rack
The slide rails are delivered already mounted in the flange mounts on the rack. You must
remove the slide rails from the rack and attach them to the disk enclosure.
Open the side doors, as this is the easiest way to access enclosure slide rails, which are
mounted in the stationary flange mounts. See Figure 9.
1. Pull the left slide rail forward in the flange mount until the lock button locks into
place.
2. Press in the button on the back of the slide rail (1) to unlock it from the stationary flange
mount, and slide it out until it stops.
Figure 9. Releasing the Lock Button from the Lock Button Mating Hole
1
2700
Stationary Flange Mount
Locking Button attached
to Enclosure Slide Rail
Left side
of Rac
k