Filter
Top Products
Chapter 2: Installing in a Ciprico Rack 21
1. Attach the rear bracket to the support angle with four 1/2" #10-32 screws. (Figure 14
shows a right support angle.)
Figure 14. Installing Support Angles
2. Install the front end of a support angle into matching holes at the front of the rack with
two 1/2" #10-32 screws.
3. Insert two cage nuts onto the back channel mount over the holes you aligned.
4. Align the rear (bracketed) end of the support angle with the holes in the back channel
mount.
5. Fasten the rear bracket attached to the back of the support angle with two 1/2" #10-32
screws through the cage nuts.
6. Repeat steps 1 - 5 to attach the other support angle to the rack. The left support angle
should mirror the right and be at the same height.
2288
Front
Channel
Mount
Back
Channel
Mount
Rear Bracket
1/2” #10-32
Screws -
4 per side
1/2” #10-32
Screws -
2 per side
1/2” #10-32
Screws -
2 per side
Cage Nuts -
2 per side
Support Angle