Filter
Top Products
22 FibreSTORE RAID System: Rack Installation Guide
Installing Mounting Brackets
A controller enclosure is shipped without the mounting brackets installed; you must install
them before you install the controller enclosure in a rack. The Ciprico-provided install kit
contains the parts you need to attach the mounting brackets to the controller enclosure and
the enclosure to the rack.
Install the controller enclosure from the front of the rack.
1. Attach the brackets on both right and left sides of the controller enclosure
with three
counter-sunk Phillips head 1/4" #6-32 screws, as shown in Figure 15.
2. Align the slots on the mounting brackets of the controller enclosure with the cage nuts
as shown in Figure 15.
Figure 15. Installing the Controller Enclosure in a Ciprico (Hoffman) Rack
3. Rest the controller enclosure on the support angles and slide the enclosure back and into
place.
4. Secure the controller enclosure to the rack with four 1/2" #10-32 (2 per side) screws in
the cage nuts as shown in Figure 15.
2362
Controller Enclosure
Mounting Brackets
#10-32 Screws -
2 per side
Support
Angle
Cage Nuts
Controller
1
Controller
2
Controller
Enclosure
#6-32 Screws -
3 per side