Filter
Top Products
Chapter 2: Installing in a Ciprico Rack 17
3. Using caution, push the tab (2) and pull the slide rail completely out of the stationary
flange mount (3), as shown in Figure 10.
Figure 10. Removing Enclosure Slide Rail from Stationary Flange Mount
4. Repeat steps 1 - 3 for the right side.
5. Install one slide rail on each side of the disk enclosure, as shown in Figure 11. Position
the lock button assembly to the rear. Secure the slide rails, using five 3/8" #10-32 pan
head screws for each slide rail.
Figure 11. Disk Enclosure Rack Mount Components
WARNING Be very careful, not to pinch your fingers when completing this step.
2702
2
3
Stationary Flange Mount
Enclosure Slide Rail
Left Side of
Rack lookng
into the front
2430
3/8” #10-32 Pan Head Screw -
5 per side
Front Lock
Button
Front
Rear
Enclosur
e
Slide Rail