Filter
Top Products
20 FibreSTORE RAID System: Rack Installation Guide
Step 4. Installing a Controller Enclosure
When you order the controller enclosure and the rack at the same time, Ciprico ships the
rack with the controller enclosure support angles and cage nuts that correspond to the rack
configuration you ordered already installed in the rack. In this situation, skip the next
procedure and go directly to Installing Mounting Brackets on page 22.
Attaching Controller Enclosure Support Angles
If you are installing an additional controller enclosure in a rack that was not originally
configured to include this controller, you need to attach support angles in the rack. This
situation can arise if, for example, you originally ordered an AAMK36A rack and now want
to convert it to an AAMK36A2. In this situation, order the controller enclosure mounting
kit when you order the controller enclosure.
Install all controllers as specified in Supported Rack Configurations:
Configuration for One RAID System (AAMK36A) on page 6;
Configuration for Two RAID Systems (AAMK36A2) on page 7
Configuration for Three RAID Systems (AAMK36A3) on page 7;
Configuration for Four RAID Systems (AAMK36A4) on page 8
Note To install support angles, you may have to remove disk enclosures or rails.