Filter
Top Products
10
Specifications
Table 2: CC1800XL Specifications
Maximum Cutting Depth 4-5/8” with 14” blade
Maximum Cutting Depth 7-5/8” with 20” blade
Blade Shaft Diameter 1-1/4”
Blade Shaft RPM 2,600
Arbor Diameter 1” with single alignment pin
Blade Shaft Bearings Self-aligning pillow block bearings
Blade Shaft Drive Three or four 3VX V-belts
Blade Mounting Right or left
Blade Raise/Lower Screw feed
Blade Coolant Dual multi-spray water tubes
Blade Guard Attachment Slip-on up to 20”
Handlebars Adjustable height and reversible
Transmission Eaton model 6, or push model
Drive Speed 0-80 ft/min
Electric Start GX620 Honda only
Fuel Capacity Two gallons
Tachometer/Hour Meter Standard on GX620 Honda
Quick Disconnect Blade Flanges Standard
Frame Lift Standard
Uncrated Dry Weight 280-415 lb (add 40 lb for crated weight)
Table 3: Engine Specifications
Manufacturer Honda Briggs Vanguard Honda
Model GX390 N/A GX620
Fuel Type Unleaded gasoline Unleaded gasoline Unleaded gasoline
Air Filter Cyclone Dual element Snorkel type, dual element
Low Oil Alert Standard Standard Standard
Note: Refer to the engine manual for additional information.
Table 4: Electric Motor Specifications
Manufacturer Baldor Electric
Phase/Voltage
1PH-230V, 3PH-230V, 3PH-460V, 3PH-575V
Note: Refer to the motor manual for additional motor specifications.
Table 5: Hydraulic Motor Specifications
Manufacturer
Danfoss Hydraulic
Displacement (cubic inches (CI)/revolution)
1.16CI, 1.55CI, 1.94CI
Note: Refer to the motor manufacturer for additional motor specifications.