Filter
Top Products
CC1800XL Concrete Saw Manual 17
Figure 20: Transmission Lever
Engaging the Transmission
1. Place the speed control lever at Neutral
2. Start the engine.
.
3. Pull the transmission engagement lever down to
Engage
Disengaging the Transmission
.
1. Place the speed control lever at Neutral
2. Push the transmission engagement lever up to
.
Disengage
Fuel System (Gas Model)
.
WARNING
• DO NOT operate the saw with a fuel leak.
• DO NOT fuel the saw with the engine running.
• DO NOT smoke or expose fuel to
open flames when filling the fuel
tank or working with fuel.
CAUTION
• Clean up any spilled fuel prior to starting the
engine.
Fueling the Saw
Fill the fuel tank as necessary.
1. Lower the saw so the engine is level.
2. Stop the engine and let the saw cool down.
3. Remove the fuel tank cap.
4. Fill the fuel tank with unleaded gasoline. Refer to the
engine manual for refueling information.
5. Replace the fuel tank cap and tighten to secure.
Fuel Shutoff Valve
1. Open the shutoff valve to open the fuel line.
2. Close the shutoff valve to close the fuel line.
Storage
Refer to the engine manual for fuel recommendations
when storing the saw.
Engine/Motor
Refer to the engine/motor manual as the primary source
for information.
WARNING
• DO NOT leave the engine/motor running
unattended.
• Always operate the saw in well-
ventilated areas. Concentrated engine
exhaust can cause loss of
consciousness and/or death.
• All electric motor saws should be properly
grounded prior to operating.
Engine Governor (Gas Model)
The engine governor (located at the top of the engine) is
factory set for an engine speed of 3,600 RPM. DO NOT
change this setting to prevent engine damage.
Occasionally measure the engine speed and adjust to
the factory setting, as necessary, following the steps
below:
1. Use a handheld tachometer or other appropriate
device to measure the engine speed at the engine
crankshaft.
2. Adjust the engine governor to correct the engine
speed.
Figure 21: Engine Governor