Filter
Top Products
CC1800XL Concrete Saw Manual 15
Figure 14: Connecting Water Hose
Removing the Blade Guard
1. Disconnect the water supply hose from the blade
guard.
2. Use the handle on the blade guard to rock the guard
back and forth while lifting the guard off of the
tapered mount.
Flange Guard
Installing the Flange Guard
1. Fit the tapered mount on the backside of the flange
guard over the tapered blade guard mount on the
frame.
Figure 15: Flange Guard
Removing the Flange Guard
1. Lift the flange guard off of the tapered blade guard
mount.
Water System
The water system cools the blade and minimizes dust
when cutting. Keep the water hose, when cutting on the
left side of the saw, away from the muffler assembly to
prevent hose damage. Note: Always test the water
supply for adequate pressure and flow prior to cutting.
Water Valve and Supply Hose(s)
1. Connect the water source hose to the water supply
fitting.
Figure 16: Water Supply Fitting
2. Connect the water supply hose to the blade guard.
3. Turn on the water valve to start the water flow and
turn off the water valve to stop the water flow. The
water flow between these two points
increases/decreases based on the valve’s position.
Note: Disconnect and reconnect the hose when
moving the blade guard to the opposite side of the
saw.
Note: Turn on the water just before cutting to avoid
wasting water
Moving the Water Valve
.
The water valve can be moved to the left side of the saw
if preferred (on models with no fuel tank under the
control panel); however, it must be moved to the left side
of the saw when the hydraulic valve assembly (hydraulic
motor saw) is moved to the right side of the saw.
1. Remove the screws securing the water valve to the
frame upright.
Figure 17: Water Valve Assembly