Filter
Top Products
30
Appendix B
Daily Maintenance Task Chart
Table 6: Daily Maintenance Task Chart
Date
1.
Lubricate blade shaft bearing
grease fittings daily or two to
three times daily when dry
cutting.
2.
Inspect belts after first four
hours of use, and then daily for
tension and wear. Replace or
re-tension as necessary.
3. Inspect saw for damages.
4. Tighten loose nuts and bolts.
5.
Verify that drive wheels fully
engage rear wheels when
transmission is engaged (self-
propelled model).
6.
Clean air filter daily or two to
three times daily when dry
cutting (see engine manual).
7.
Check fuel level and fill as
necessary.
8.
Check engine oil level and fill
as necessary (see engine
manual).
9. Wipe down saw’s exterior.
10.
Wipe down engine’s/motor’s
exterior and guards.
11. Look for fluid leaks.
12.
Re-tension rear drive chain as
necessary (self-propelled
model).
Refer to engine/motor manual for daily engine/motor maintenance tasks.